Quantcast
Channel: PTC Community : Discussion List - All Communities
Viewing all articles
Browse latest Browse all 11410

what have I done.....

$
0
0

what have I done to cause this behavior when pulling diameter dimensions in drawings?

 

When I pull diameter dimension for a hole in a drawing they behave this way:

 

     -the largest denominator is set at 4 for example a 1 7/8" hole displays as 2"

     - when I toggle between the default format of  "fraction" then to decimal then back to fraction the denominator is automatically set back to 16.

     - all other dimensions in the drawing have a default denominator of 16

     - when I create a linear dimension (point to point) on a hole the denominator is set at 16.

 

I have looked through my config and I can't seem to find what is causing this.

 

Anyone have any suggestions?


Viewing all articles
Browse latest Browse all 11410

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>